Need help with Mobile Link? Visit the Mobile Link support site.
This article explains why priming is required for Generac water and trash pumps and how to prime the pump before starting the engine. Follow the steps to remove trapped air, restore suction, and avoid running the pump dry for reliable pumping performance.
To prevent future starting issues, it is recommended to drain the fuel from a portable generator or pump before storing it for more than 30 days; the general steps include turning off the fuel valve, disconnecting the fuel hose from the carburetor and directing it into an approved container, draining the fuel from the tank, removing the...
No, water must be under 100°F. Operating the pump with hot water can result in premature pump failure not covered under warranty.
To troubleshoot low/no pump suction or weak discharge, check if the vertical suction lift and total head lift are within the allowed range, if the pump has been primed, if the end of the suction hose is submerged in water and suction hose strainer is obstructed, if suction hose or port is leaking air or water, if discharge hose or port is...
The vertical suction lift refers to the verticle distance between the water source and the pump's inlet.
Use an SAE-rated high-detergent oil that meets API Service Class SF requirements for gasoline engines, similar to your car. Refer to your owner’s manual for details.
The serial number for a Generac Pump is typically located on the pump's data label. The data label can typically be found on the side of the pump housing.
Yes, the maximum head lift is between 80-149 ft. depending on the unit.
Yes, the maximum vertical suction lift for most units is 25-26 ft. in standard conditions.
To choose the right pump, assess the water condition - clean water pumps are suitable for swimming pools, hot tubs, or garden ponds, while semi-trash or trash pumps are best for water with sand, mud, or small debris, and chemical pumps should be used for chemical transfers.